Turbo advice
-
Hello Jay,
I plan to fit a turbo to my 1.6 DOHC manual, using a mazda 323 turbo manifold running emanage or MS, and an uprated clutch! so i dont honestly know how the autobox will handle your extra torque, if at all ! New to mazda,
but not turboing ;)Sam.
-
is it a streight foward fit or dose it need a bit of moding ?
-
piece of piss jay :)
uv'e got my email ;)
-
i think welly should turbo my ze as there is just far too many klzes now!!
-
:wink:
It's easier than people think to make your own turbo kit…
-
I've been thinking about adding a turbo to the V6, I know the basics but would appreciate a "How To". The subject of fitting a turbo has roused more interest than a lot of other topics. I know this is the 4 cylinder area but it's still relevant. :)
-
v6 has 2 exhaust manifolds? correct…so in theory u can twin turbo it... ill be quiet now.
hope there is 2 exhaust manifolds anyway, its not a inline 6 lol.
-
hi welly i cant find the e-mail about turbo any chance you could send it again please. thanks.
-
@02e8b82078=jay:
hi welly i cant find the e-mail about turbo any chance you could send it again please. thanks.
whos email address mate? mine?
-
you e-mail about fitting a turbo to my car tanks mate
-
Leehumphreys91@hotmail.com - my msn and email
-
@cb1818527f=jay:
is it a streight foward fit or dose it need a bit of moding ?
Straight forward fit so im led to beleive, havent actually offered it up yet though, finding a T25 sized turbo to fit is proving a bit difficult ! must be 323 specific?! a bit like bloody pug turbos.
:cry:
Im hoping to do it for 500 quid ish :D cant get cracking on dishcharge flange, downpipe or boost pipes/intercooler till I source a turbo mind.
-
Rover 620 and 200sx are T25 turbo's ;)
Make sure u dont over do it with boost, and have enough fuel..or ull start pinking and blowing pistons
-
Had a look at those already ;) They have a rectangular flange, were as this
323 mani I have has a very sqaure flange, guess I may have to get a gasket to find out for sure, or even make up an adaptor block if I cant find one that fits right up. ( I work in metal fab) dont really want to go this route though!Dont worry wont being running loads of boost and will run a wideband lambda, and get someone who knows what there doing to map my emanage/ms. :)
Do these engines run a knock sensor as standard?