Jamess new mx3
-
lovely stuff :)
-
Good job lee, sounds nice. :)
-
sounds great mate. looks brill too. :D
god i miss those roads down there. can you believe its been a yr :oops:
-
yeh its been a while i still remember are meet on portland lol and the drive home was good
still wateing for the bits to turn up and its a shame youtube made my vid blury love this pic
-
liking that pic. and the white spots lol
i'll have to come down sometime :shock: :D 8)
-
been a while since i last up dated i had a dyno day and fitted one of freedoms dores
-
Again good figures on the dyno! Car's looking the money :D Very very clean
-
as you alread know
that was a very sad day
but glad youve fitted one,
whens the next cheque in the post :P
-
when you pm me your full address lol
-
139 hp? I tried to look through your worklog but what is that with a CAI, exhaust and a stock k8?
-
i got 140 and 148 on a k8, don forget we run 98+ ron go go juice
-
@ad7d5d2d3f=robx1r:
go go juice
:lol:
-
@5a81fb2dc9=Mooneggs:
139 hp? I tried to look through your worklog but what is that with a CAI, exhaust and a stock k8?
Don't forget we also have a tendency to measure at the fly, not the wheels…
-
im running manifold decat powerflow back box
and a green air filter without a cold air feed
-
he he new mod led heater controles woo coz its not pluged in you cant see but i also did all the green ones in the top of the switches
and for some reson in the pic the red dident come out but it looks ok
-
i'm loving the blue controls mate.
You still want my speedo etc? sorry it took so long to reply, been kinda shit due to redundancy :cry:
-
nah sorry picked up freedoms when i got the lambos
-
would you care to share how you did the blue lights? I want to change mine from green to blue as well…
-
took it all apart un solderd the standerd genn led in the top (the selection led) re solderd with blue ones
took out the 2 standerd switch bulbs
the the clear plasic defuser thers notches about each switch i hot glued an led on the top of each wired them all together and solderd the 2 wires right to the bord where the standerd bulb went tryed to close it back up but riped the led out so i cut holes around where the leds were pulled the legd up through th caseing and re wired it exeternaly if neede i can take it out agen to take pics
-
finaly finished polishing the rockers ready for the new engine
