Whats under the bonnet badge?
-
as above :D
-
two holes!.
-
rsoles! need a solution….
-
some take the mazda wings badge off mk2 mx5. fits over perfect aparantely.
I have a spare badge if you need it?
-
wanna go badgeless, cheers for the offer though!
red electrical tape it is then,lol
-
Metal, Air, Engine, Road, Drainage system, A whole lot of nature, Gia, A while lot of nature, Drainage system, Road, Engine, Air, Metal, Air, clouds, A 747, Space.
-
@3b0968fdbf:
Founding member of the Burt Reynolds Fan Club.
can anyone join?
-
Yup, You just have to love the horrid yank tanks from the Car porn thread
-
weld, sand, fill and spray if thats at all possible.
Ryan had spare authozam badge for sale £8 delivered i think ?
-
Leave the two holes and make it look like a piggy :lol:
-
Well you could put in some LED's, some spiked bolts, or you could fit one of these cos theyre super cool!
-
Think I'll just blank it with some tape for now,
before the weathers better than I can fill and spray….. does it just literally pull off?
-
Heat it up with hairdryer then prize it off with something blunt,
It's same for rear badges.
Then t cut the hell out of it til it matches
-
Thankyou.
Need to T-cut teh whole car again soon so thats ney bother :)
-
@cb371fa5fc=Garfy1981:
Heat it up with hairdryer then prize it off with something blunt
**Aie! No!
Heat it up with a hairdryer (a lot), then saw it off with some dental floss. The lugs are at either edge in the middle, so once you reach a point where they're your only obstacles pull it off with your fingers.**
-
thats alarmingly ingenious!
-
Hot air gun, then use a plastic filling spreader to prise it off, as plastic won't damage paintwork, don't get too close with heat gun mind. In relation to filling holes afterwards, really would be better off welding holes from inside, as normal polyester filler will most probably eventually 'shrink back' due to heat from engine/sun, even fibreglass filler will shrink backand leave two tiny cirlcles where holes were, if welding not an option, I've used a marine based epoxy filler, takes 12 hours to fully cure and goes like concrete
-
@590d81bd4d=mx3gulf:
Hot air gun, then use a plastic filling spreader to prise it off, as plastic won't damage paintwork, don't get too close with heat gun mind.
Will this method get the badge off without breaking the pins?
-
what about sliding a feeler guage between the pins and then holding either edge of the guage and lifting it off rather than prying?
-
I just prised mine off just like gulf said, and pins came out fine, badge was intact no problem.
-
If your interested