Jay mx3's kl-ze drag car project
-
@9dca10ed14=jay1987:
looking good jay, are you gonna bolt up the ud pulley and flywheel ?
:) did the flywheel and clutch today and ill put the ud pully on once the cambelt is on.
just been painting all day things like
- the sump
-waterpump pully oil filter heat sheald
-cam pullys
-cam covers again
tomarrow it start putting all back together :D :P
- the sump
-
getting there now and almost ready to go in just need to put the cam belt on
also got the m62 supercharger on the way so trying to find out as much a i can on fitting it but having no look so far.
-
it should be mine! :D
-
nice work mate. i dunno bout that clutch tho.. good luck.
did u put the thermal spacers on and the ud? also cleaned injectors? bored throttle body, fuel pressure regulator? uprated fuel pump? just some things i was gona do!
cant wait to see this running, been a long time! :D
-
@fc48ddd0b2=jay1987:
nice work mate. i dunno bout that clutch tho.. good luck.
did u put the thermal spacers on and the ud? also cleaned injectors? bored throttle body, fuel pressure regulator? uprated fuel pump? just some things i was gona do!
cant wait to see this running, been a long time! :D
it has been a while
thermal spacers are on the ud will go on once the cambelt is but may have to chanege it when the sc goes onim just going to get it running then look into fitting the sc i think i need quite a few parts
-
supercharger came today felt like chrismas again lol
-
awsome..wat psi u thinking?
-
Don't now yet
Just an update the engine is now finaly in the car :lol: it was realy heavy had to put it in by hand as I'm too tight to rent an engine lift lol
-
Go on my son heave it in there :D
-
I remember 4 of us lifting mine with a breaker bar!, suprisingly the k8 actuallly seemed alot lighter!.
-
It's finaly getting close to be running :lol: :lol: :lol: can't wail lol
-
nice….make a vid buddy!
-
just a few pics of the engine in now its light lol
-
Looks great! Nice colour scheme.
-
Looks good Jay, what have you got left to do to get engine running?
-
Looks great mate, bet you can't wait to give it some beans!
-
Thanks fellas
Things left to do
Find out exactly the left engine mount fits
Fit drive shafts
Finish plugging in all ther wires again find where they go
Fit a starter motor , altanatoer , power steering pump
Get a new front window
Get another 4 point harness
Fit lexan rear screen
Put all new better breaks on
Get an exhaustSo still plenty to get an fit lol
But can't wait till its done lol
-
had a bit of spare time i gave up on the gadges in the air vents so did this instead just need to heat wrap the wires then wire them in but its a start for now
also a friend was getting rid of a spare set of seats so i grabbed them in a flash as they were realy realy cheap there not in the best of condition but they will do for daily driving, nicer to sit in than the fibre glass seats
they will go back in for the track as they are lighterthis is the bad seat the other is in better condition
-
This is turning out to be a real cracker! Ill be interest on how you fit that Super Charger. Take lots of pics!
-
Thanks I have loads of plans for it just not loads of time lol its took 2years to get this far ill take loads of pics for you 8)
