FAO: anyone fitting new wishbone ball joints.
-
The new rear bolt that comes with it, is splined
and needs to be pressed in!
Well the ones I got from ROC do, some on ebay seem
to have it done already?!
-
From my experience if you just tighten the nut on to it, the splines will cut through themselves by the tightening action :) So no press needed
-
Phew! Thanks for replying Marco,
not actually done it yet was going to press them in today at work,
guess I wont bother then :D
-
I can confirm what Marco says. They will pull in, just use a big ass breaker bar to tighten them up to make life a bit easier!
Broke my vice trying to press them in! Cast Iron fcuker too!!
-
aye, massive breaker bar did it :D
-
just because I haven't seen it… what does FAO mean??
-
For the attention of. :)
