Strut brace
-
any one know of a strut brace that will go over the malania inlet with thrmo spacers ?
I had thermo spaces but a diff inlet i used a couple of washers seemed to do the trick.
-
I'm using a mazdaspeed strut bar… and it still slightly touches it even with some extra washers as spacers... pics in my RC worklog
Also I was using a corksport strut bar with extra nuts underneath to raise it up but it was cutting into the bar.
-
J my best advice i can give would be to get one made to measure fella putting in extra bols and spacers etc will no doubt create a weak point in the set up..not a good idea
-
yeh i cant do that anyway coz of my kpsort set up ther studs are shorter
-
so are you after a brace like this one
-
yeh but thats prity much waht i have buit i have thermo spacers so inlets a bit higher
also why is his pressure regulater between the fule rales ?
-
^ that looks a little flimsy around the strut top towers were it joins
the bar though!
could'nt you use thicker material around that area but countersink the nuts into it?