Jays daily driver
-
They will do for now
-
@5a87f82e95=jay:
They will do for now
yep until you bend them as do most when incorrectly fitted or adapt the wrong ones fella…Sorry had to say it... :roll:
-
I'll get rid and find out how to do it right then
Thanks
-
look up inxx fella there the supplier for aftermarket ones see if they do a set for the mx3 i know they do a set for the mx5 could use those i suppose…
-
Thanks
If there incorrectly fitted how should the be fitted as they work fine.
-
if there too long and on a too shallow angle then instead of just pushing together as supposed to they dont and you close the bonnet and they just bend in half..You may just be lucky J …
-
take a look at the pic on this link its for a set of lifters for a veccy you'll notice there alot shorter than yours and my bonnents alot bigget than a mx3..i have lifters on the gsi and the bonnet opens alot higher than what your pic looks J,.. like said mine are alot smaller too..
-
Ok ill keep an eye out for some shorter ones what's the correct angle for them
-
id look for a set for the mx3 there only £20 per set from inxx but if they dont supply a set for the mx3 try a set for the mx5…
-
Thanks I will do
-
@09bfef130a=jay:
just a couple of the bits from rustymx3 thanks fella
Got it to fit better than I did (well, I am a lazy twat like) and Jay dude, vacuum the car FFS!
-
@e1bad594ee=RustyMx3:
Jay dude, vacuum the car FFS!
Hahahaha lmao…
-
Jay, with those bonnet stays, did you use the threaded ball joint part from a 106 too? straight into the wing/bonnet?
Ive had the INXX ones before (Nova items on a 205), they started rusting after a good few months! was a bit dissapointed, I like what youve done .
-
That looks smart, was it hard to fit? :D
-
ill get some pis up were i bolted the but after ive ajusted the for you
-
no worrys, yours isnt a standard bonnet though is it?
-
no but its the same molding underneith
-
just a quick update
just got these from jay1987 thanks jay lol
some new rear lights witch i love think it looks well
some glow dials which i need to finnish fitting
and some tinted front inducators
just need to sort the engine out now and a good clean lol
-
oh no jay broke his temp needle lol!!, its ok i broke by fuel needle when i done mine. Its a easy fix but you need another cluster.
Hows things with engine?
-
I have 2 sets of those lights for a good reason, they steam up more than my shower cubicle if its been raining, absolute nightmare to keep dry, so I have to so I can swap when its been raining like a biatch
The K8ZE has sold now jay so hope you get the engine sorted soon
I like the dials, they are on my to do list at some point