Remove the Front Bumper (with Inner Bar)
-
Removing the bumper on a MX-3
After doing once it’s a lot simpler than i thought it would be. Heres what I did, i think it’s simpler to remove the bumper with the inner bar than try without.-
Loosen Wheel Nuts, Jack the car up place axel stands and take wheels off
-
Remove Splash Guards in Arches and Under the car ( loads of 8mm and 10mm bolts)
-
Remove the Radiator cover/Air intake (8mm Bolts)
-
From Under the car almost in line with the lights you will see 14mm Nuts (1 each side)
-
From above in the engine bay look towards the light between the Radiator and Air-Con Condenser for 14mm Nuts (again 1 each side)
-
Screws on top corner edge of the bumper/wing
-
Pull Bumper off disconnect lights (Fog, Side and Indicators)
-
Done.. Now follow reverse to put back on.
I took loads of pics when i did this… but you can see ugger all in them.... I can post if required.
Hammy
-
-
This is dead handy, I am doing this on saturday to do some paint etc